08-24-2021, 05:26 AM
Acrylic plastic refers to a family of synthetic, or man-made, plastic materials containing one or more derivatives of acrylic products acid. The most common acrylic plastic is polymethyl methacrylate (PMMA), which is sold under the brand names of Plexiglas, Lucite, Perspex, and Crystallite. PMMA is a tough, highly transparent material with excellent resistance to ultraviolet radiation and weathering. It can be colored, molded, cut, drilled, and formed. These properties make it ideal for many applications including airplane windshields, skylights, automobile taillights, and outdoor signs. One notable application is the ceiling of the Houston Astrodome which is composed of hundreds of double-insulating panels of PMMA acrylic plastic.
Acrylic plastic sheets are formed by a process known as bulk polymerization. In this process, the monomer and catalyst are poured into a mold where the reaction takes place. Two methods of bulk polymerization may be used: batch cell or continuous. Batch cell is the most common because it is simple and is easily adapted for making diy acrylic key chain sheets in thicknesses from 0.06 to 6.0 inches (0.16-15 cm) and widths from 3 feet (0.9 m) up to several hundred feet. The batch cell method may also be used to form rods and tubes. The continuous method is quicker and involves less labor. It is used to make sheets of thinner thicknesses and smaller widths than those produced by the batch cell method.
Any excess material, or flash, is trimmed off the edges, and masking paper products or plastic film is applied to the surface of the finished sheets for protection during handling and shipping. The paper or film is often marked with the material's brand name, size, and handling instructions. Conformance with applicable safety or building code standards is also noted.
Acrylic plastic is not easily recycled. It is considered a group 7 plastic among recycled plastics and is not collected for recycling in most communities. Large pieces can be reformed into other useful objects if they have not suffered too much stress, crazing, or cracking, but this accounts for only a very small portion of the acrylic display case boxes plastic waste. In a landfill, acrylic plastics, like many other plastics, are not readily biodegradable. Some acrylic plastics are highly flammable and must be protected from sources of combustion.
Although the composition is pretty much the same, acrylic has many brand names. Plexiglas was the original trademark name when the Rohm and Haas Company first introduced the product to a mass market, but many others have established their own brand names including Lucite by du Pont and Acrylite by Evonik Cyro LLC. Some other common brands are Perspex, Oroglass, Optix, and Altuglass.Injection molded acrylic is manufactured by injecting acrylic or polymethyl methacrylate material into a mold. This transparent thermoplastic makes a great alternative to glass, which is why it is commonly used to manufacture bakery bins, sunglasses, and display risers. Unlike polystyrene, injection molded acrylic table number plate can be made without the issues of hazing or coloration. Additionally the material is much stronger and has minimal relief markings when removed from the mold. Injection molding takes less labor than hand-crafting, which results in a lower cost.