+- Osborne Acres Community (https://osborneacres.com)
+-- Forum: My Category (https://osborneacres.com/forumdisplay.php?fid=1)
+--- Forum: My Forum (https://osborneacres.com/forumdisplay.php?fid=2)
+--- Thread: Customized Door Drop Seal (/showthread.php?tid=38)
Customized Door Drop Seal - shenq41 - 04-20-2021
Description
ADDS-H-1 is an adjustable, automatic door bottom seal, which is spring, loaded to lift clear of the floor when the door is opened. Operated automatically by pressure against the doorstop on its adjusting screw and incorporates concealed fixings.
Location
Face mounted on the bottom of single and double butt hinged doors
Min/Max Gap
3 to 15mm
Seal material
Black TPE Rubber
Standard finish
Aluminum anodized Satin Clear (Silver)
Installation
SINGLE INWARD OPENING DOORS
FIG.1 Remove cover strip with a hacksaw, cut the drop seal at least at latch side squarely to width between stops less 2mm for clearance on latch side .If door width less than 750mm,trim equal amounts from each end to avoid mechanism damage. 450mm is the minimum operable size.
FIG.2 Fit adjusting screw (the longest screw) by fully inserting in the hinge side end of the drop seal.
FIG.3 With door closed, position drop seal level with door bottom and firm against hinge side stop. Screw fix.
FIG.4 Open door and withdraw adjusting screw two turns. For soft timber, fit thumb tack strike
FIG.5 Close door gently and observe action of the drop seal. Seal should engage sill lightly.
FIG.6 Cut cover strip to width of drop seal. Fit cover strip in channel
FIG.7 Push in cover strip lock tabs at each end to hold cover strip. Tap in tabs flush with a small hammer.
DOUBLE INWARD OPENING DOORS
Follow FIG.1-FIG.7, but do not allow 2mm clearance on the latch side of the door in FIG.1.Customized Door Drop Seal
website:http://www.firestopchina.com/acoustic-and-drauht-seal/door-drop-seal/